Factory Customized Electrostatic Powder Coating Spraying Painting Machine For Sale THD602

Specifications

Input Voltage:210V/240V

Frequency:50Hz

Power:50W

Output Voltage:21VDC

Output Current:0-200uA

Maximum output voltage:0-100KV

Water vapor content of compressed air:1.3g/m³

Oil vapor content of compressed air:<0.01g/m³

Input air pressure:0-0.6MPa

Output air pressure:0-0.5MPa

Powder hopper air pressure:Up to powder fluidization

Electromagnetic valve voltage:24VDC

Residual oil in compressed air:max0.01g

Residual water in compressed air:max1.3gNm (dew point 7℃)

Assembly diagram

Commisioning: After long transportation, the machine might bear strong shock, so before using the machine, must check machine structure is fasten or not, all parts are still there, according to the assembly drawing in operation manual, to connect the whole machine, then check the power supply meets the requirement of the machine or not, check the special ground wire is correct or not, then can power on for commissioning.

Commissioning method: connect power supply plug, ground connecting well, open the machine power switch, power supply light up, then press gun trigger switch, then twist high voltage adjustment button at clockwise direction. If voltage increase, it means high voltage electrostatic is generated, machine starts working.

Use direction: Add powder into hopper, less than 2/3 is the best. Then adjust hopper fluidized air volume, make the powder inside hopper fluidized and loose, then take the gun by hand, press gun trigger switch, then take out and twist powder volume adjusting 2-4 air volume, atomized adjusting switch 0.01-0.25 air volume, adjust to the requested powder volume, then come into service.